| |
Sanyo Volume Educational Pricing
| Model |
Image |
Features |
|
1 - 4 |
- |
5 - 9 |
- |
10+ |
PLC
XW-200 |
 |
XGA
2200
lumens
ZOOM lens |
|
$579.00 |
- |
$569.00 |
- |
$559.00 |
|
Replacement Lamp
$199.00 |
|
|
|
|
|
|
|
PLC
XW-250 |
|
XGA
2600
lumens
ZOOM lens |
|
$679.00 |
|
$669.00 |
|
$659.00 |
|
Replacement Lamp
$199.00 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| PLC XU-300 |
 |
XGA
3000 lumens |
|
$790.00 |
|
$779.00 |
|
$759.00 |
|
Replacement Lamp
$299.00 |
|
|
|
|
|
|
|
|
Tips to Extend the Life of Your Projector Lamp
|
|
1. Do not handle the lamp without gloves. Oils
and deposits from hands and fingers can cause hot spots, which may
result in premature lamp failure.
2. Keep the projector air filters clean. Clogged filters and/ or vents
will not vent heat properly, and can cause the projector lamp to
overheat and fail.
3. Do not place anything on top of the projector or in front of the
intake or exhaust vents. This will cause the lamp to overheat and
fail.
4. When you replace the lamp housing, make sure the new housing is
seated completely. Apply pressure at the base of the housing until it
is completely secure.
5. Hot lamps are very fragile. Always move the projector after the
lamp has completely cooled. Shock and vibration applied to hot lamps
may cause the lamp filament to break.
6. Do not unplug the projector until the lamp has properly cooled.
After the projector has been shut off, the fan will remain on for
about 5 minutes. This aids in cooling the lamp evenly and completely
and decreases the chance of early lamp failure.
7. Do not turn the projector on and off frequently during
presentations. Each time the projector is switched on, the inrush of
power causes stress on the lamp filament. Try to minimize on/ off
cycles.
8. Some projectors offer "low lamp" or "economy
mode" options. Use them whenever possible. These options have
been developed to extend lamp life.
|
| |
|
